Use the command-line interface (CLI) through the mini USB console port or RJ-45 RS232 console port. Use the local browser interface through the OOB port or any Ethernet network port (see Use the local browser interface to configure the IP address). Local browser–based management interface.To configure the IP address of the switch, use one of the following methods: By default, the switch functions as a DHCP client. You can access the switch through the out-of-band (OOB) port (which is also referred to as the service port) through a console port, or through any Ethernet network port. For more information about installing an SFP module, see the hardware installation guide. If purchased, SFP modules and cables are shipped separately. Use a NETGEAR AXC761 (1 m) or AXC763 (3 m) cable for a fiber port.Use a NETGEAR AXM761, AXM762, or AXM764 for a fiber port at 10 Gpbs.Use a NETGEAR AGM731F or AGM732F for a fiber port at 1 Gbps.Use a Category 5e (Cat 5e), Category 6 (Cat 6), or Category 6a (Cat 6a) cable a for copper port at 1/2.5/5 Gbps.We recommend using the following cables and SFP modules: If this action does not resolve the problem, see the troubleshooting section of the hardware installation guide for more information. If the Power LED does not light at all, check to see that the power cable is plugged in correctly and that the power source is functioning.See the troubleshooting section of the hardware installation guide for more information. If the POST fails, the Power LED remains solid yellow.
0 kommentar(er)
